Abicor Binzel MF1-Laser Front/Rear Betriebsanleitung Seite 42

6 Commissioning
There are three markings on the housing to indicate the scalability of the contact pressure.
 Fig. 15 Scale on page EN-18
The appropriate contact pressure can be found in the table.
 Tab. 12 Setting the contact pressure on page EN-18
1
Fig. 15
Indicator
First marking
Second marking
Third marking
Tab. 12
The contact pressure must be set to the appropriate value so that slippage does not occur.
To reduce wear on the MF1-Laser and achieve the longest service life possible, set the contact pressure as
low as possible.
EN - 18
Markings for contact pressure
Scale
Setting the contact pressure
MF1-Laser Front/Rear
1
Force ± 40 N
45 N
135 N
225 N