Automatic Service Update; Tuning Analogue Television Channels - Beko B43L 5740 4B Bedienungsanleitung

SETTING FURTHER CHANNELS

Automatic service update

If this function is activated, possible changes of
network operators are updated automatically.
The unit must be located in stand-by mode.
This updating affects all types of reception -
terrestrial, cable and satellite.
1 Open the menu with »MENU«.
2 Select menu item »Settings« with »
< >
» « or » « and press »OK« to confirm.
3 Select the menu item »Source« with »
<
» « and press »
– »Source« menu is active.
4 Select the line »Advanced« with »
» « and press »OK« to confirm.
Λ
5 Select the line »Automatic Service Update«
with » « or »
V Λ
<
update with »
6 Press »EXIT« to end the setting.
78 / 88 TR
«, »
V
>
« to confirm.
V
« or
V
« and select the automatic
>
« or » « (»On«).
-----------------------------------------------------
Tuning analogue television
channels
This setting is only necessary if you cannot
receive any digital channels and you have not
carried out an analogue search during initial
setup.
The television channel can be set directly or
using the search.
«,
Λ
Setting all analogue television channels
The analogue television stations are listed in the
« or
channel list after the digital television stations.
Note:
Plug the rooftop antenna cable (for
7
analogue television stations) into the ANT
IN socket on the television.
1 Open the menu with »MENU«.
2 Select menu item »Settings« with »
< >
» « or »
3 Select the menu item »Source« with »
<
» « and press »
– »Source« menu is active.
4 Select the line »Automatic Channel Search«
with » « or »
V
confirm.
5 Select the option »Air (DVB-T/T2)« or
»Cable (DVB-C)« with »
confirm the source you are receiving analog
broadcast from by pressing »OK«.
6 Select the option »Digital« with »
» « and press »OK« to remove the small
Λ
tick.
7 Press » « (red) to start searching.
« and press »OK« to confirm.
« to confirm.
V
« and press »OK« to
Λ
« or »
V Λ
V
Television / User Manual
«, » «,
V Λ
>
« or
« and
« or