Beko B43L 5740 4B Bedienungsanleitung Seite 165

SETTING FURTHER CHANNELS
DISEqC Mode
Based on the number of current satellite
system, select the option »Off« »DiSEqC
<
1.0« with » « or »
– »Off«: For satellite systems with single
antenna.
– » DiSEqC 1.0« switch allows for receiving
from maximum four satellites at the same
time.
From »LNB Selection« use »
to make the »1/4«, »2/4«, »3/4«
or »4/4« selection for the satellite
that corresponds to relevant DiSEqC
positions.
8 Exit the antenna settings with »
9 Select the Channel Type.
Press » « or »
V
want to search for only digital channels
(Digital) or only radio channels (Radio) or
both (Digital + Radio) and press »OK« to
select and mark or unmark the »Digital«
and/or »Radio« items.
10 Select Scan Mode.
To select whether you want to search for
only free digital television channels (Free),
only scrambled digital television channels
(Scrambled) or both (Free + Scrambled),
press » « or »
V
and mark or unmark the »Free« and/or
»Scrambled« items.
11 Press » « (red) to start searching.
Notes:
When updating via the same satellites a
7
security query is displayed at the start of a
search.
If the previously stored channels should
7
be retained in the channel list and the new
channels found be added to it, then press
» « (green).
74 / 88 TR
>
«.
<
« or »
« (blue).
« to select whether you
Λ
« and press OK« to select
Λ
-----------------------------------------------------
If » « (red) is pressed, the saved channels
7
will be deleted from the current channel list.
– The »Digital Searching« menu appears,
and the scan for TV channels begins.
– The search is complete as soon as the
message »Search is completed!« appears.
Note:
The search can be aborted with »EXIT«.
7
>
12 Switch to the Channel Editor with »
(yellow);
or
press »EXIT« to end the setting.
Note:
Repeat the procedure from point
7
settings of the second satellite or any others.
These channels will be added to the bottom
of the channel table.
«
1
for the
Television / User Manual