Antenna Settings, Scr System And Searching For Digital Channels From A Satellite Automatically - Beko B43L 5740 4B Bedienungsanleitung

SETTING FURTHER CHANNELS
Antenna settings, SCR system
and searching for digital
channels from a satellite
automatically
Notes:
Your TV supports SCR system (Single
7
Channel Router – EN 50494).
The following description about the LNB
7
settings premise a substantial expertise
about the satellite systems. Ask your
specialist dealer.
1 Open the menu with »MENU«.
2 Select menu item »Settings« with »
< >
» « or » « and press »OK« to confirm.
3 Select the menu item »Source« with »
<
» « and press »
– »Source« menu is active.
4 Select the line »Automatic Channel Search«
with » « or »
V Λ
confirm.
5 Select the option »Satellite (DVB-S/S2)«
with » « or »
V Λ
confirm.
6 Select the line »Antenna Settings« with »
or » « and press »OK« to confirm.
Λ
– The »Antenna Settings« menu is displayed.
7 Select and set the required option for the
antenna settings with »
Satellite
Press »OK« then select the required satellite
with » « or »
V Λ
confirm.
LNB type
If your antenna system is equipped with
a single-cable system multiswitch, use the
option »SCR«. Press »OK« and select the
»SCR« option with »
Select the »LNB-Frequency High« line with
» « and enter the frequency with »1...0«
V
in five digits.
72 / 88 TR
«, »
V
>
« or
« to confirm.
V
« and press »OK« to
« and press »OK« to
« or » «:
V Λ
« and press »OK« to
< >
« or » «.
-----------------------------------------------------
Select the »LNB-Frequency Low« line with
» « and enter the frequency with »1...0«
V
in five digits.
Confirm the settings with » « (green).
User band
Select the number of the antenna socket
used with »
UB frequency (MHz)
Enter the required frequency for the selected
antenna socket with »1...0«.
Notes:
Use installation equipment supported /
7
suggested by your SCR Switch.
Other users / receivers connected to the
«, 7
Λ
system may be affected if the specified user
band number and frequency is changed
during installation.
User band and user band frequency is
7
specified on the SCR switch used; and each
user / receiver must select a specified user
band and user band frequency.
With SCR satellite system, auto search by
7
several users / receivers at the same time
may cause problems.
8 Exit the antenna settings with »
«
V
9 Select the Channel Type.
Press » « or »
V
want to search for only digital channels
(Digital) or only radio channels (Radio) or
both (Digital + Radio) and press »OK« to
select and mark or unmark the »Digital«
and/or »Radio« items.
10 Select Scan Mode.
To select whether you want to search for
only free digital television channels (Free),
only scrambled digital television channels
(Scrambled) or both (Free + Scrambled),
press » « or »
V
and mark or unmark the »Free« and/or
»Scrambled« items.
11 Press » « (red) to start searching.
Notes:
When updating via the same satellites a
7
security query is displayed at the start of a
search.
< >
« or » «.
« to select whether you
Λ
« and press OK« to select
Λ
Television / User Manual
« (blue).