Installation; Unpacking And Positioning; Electric Connection - Pkm EH4-50 GA Bedienungsanleitung

Do not use a socket board or a multi socket when using 220–240 V/50 Hz
alternate current (AC).All electrical connections which may be damaged
All repairs should be performed by your authorized after sales service.
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use
any aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Check that the appliance and the power cord are not damaged.
4. Connect the appliance to a dedicated socket only.
5. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
6. Install the appliance on a level, dry and solid floor. Check the correct
installation with a bubble level.
7. Connect the appliance to the mains properly.
8. The nameplate is situated inside the appliance or at the back.
While unpacking, the packaging materials (polythene bags, polystyrene pieces, etc.)
should be kept away from children. RISK OF CHOKING
You can level the appliance. Turn the adjustable feet (front side) until the appliance
is adjusted properly.
The appliance must be connected to the mains by a qualified professional, who is
familiar with, and adheres to the local requirements
and supplementary regulations of your electricity supplier.

4. INSTALLATION

must be repaired by a qualified professional.

Unpacking and positioning

Levelling

Electric connection

WARNING!
Warning!
DANGER!
27