Trouble-Shooting - Multiplex Roxxy Msb 45A Bedienungsanleitung

9. Trouble-shooting

The table below lists the most frequent queries
and their solution.
Problem
Controller does not operate,
or generates no confirma-
tion beep.
Dead band at the stick
Temperature warning
triggered
Current warning triggered
Motor jerks at start-up
Incorrect RPM display
Rotational speed incorrect
by factor of 10
Cause
The motor is not connected.
The throttle Off position is not
reached.
Overheating
Overload
Incorrect timing selected
Excessive play in geared motor.
Incorrect start-up torque setting
Motor pole count incorrect
Incorrect transmitter software
version.
Remedy
Connect the motor - the beep is generated
via the motor.
Move the throttle trim, and the throttle
stick fully in the direction of idle.
Check the servo travels and direction at
the transmitter.
Reduce the servo travels slightly at the
transmitter.
Re-locate the speed controller in a positi-
on where cooling is better.
Use a controller with a higher current
rating to suit your motor.
Select the correct setting for motor timing.
Activate the soft-start function.
Select a lower setting for start-up torque.
Set the correct pole count.
Update transmitter / telemetry display to
current software status.
GB
17