Multiplex ROXXY MSB 45A Bedienungsanleitung Seite 33

7.1 Configuring the controller using the throttle stick
Continuation of table on page 12 - car / boat mode
If you have previously activated car / boat mode (for-
ward / reverse function), this step deliberately leaves
the mode in the stick centre position.
Select level Parameter
9.1 Car / boat mode*
9 x 
Disconnect the battery from the controller when
programming is complete.
Additional notes:
Programming the controller using the throttle stick ena-
bles you to activate / disable the standard functions as
listed in the table.
The basic functions for braking power, soft-start, torque,
governor mode, governor response, motor pole count
7.2 Configuration options using a PC
Telemetry settings
Voltage
Current
Battery charge
Temperature
RPM
Idle
On
Address
Warning threshold
Address
Address
Warning threshold
Reset voltage
Address
Address
Warning threshold
Reduction ratio
2 ...32 poles
Please note:
Once you have completed the programming proce-
dure, the throttle Off position is always located at
the Centre position of the stick.
Centre
End of programming
and gearbox reduction ratio are set up at the factory
as standard. If you wish to configure the controller in a
different, expanded manner, you can quickly and simply
do this using MULTIPLEX Launcher and the appropriate
MULTIPLEX USB lead (Order No. #85149).
Supplementary adjustment facilities
Braking power
Start-up torque
Soft-start
Motor timing
Governor response
Low-voltage cut-off
Governor Stabilize
BEC voltage
Full throttle
On
4 stages
5 stages
5 stages
0-25°
5 stages
5 ... 60 Volt
On / Off
5.0 ... 8.0 Volt
13
GB