Lenz Digital plus GOLD maxi Informationen Seite 38

38
Example 2: You wish to read out the present value of CV902 of the S.U.S.I. module:
3. Enter 902-800=102 in the indicator CV126.
4. Read out the transport device CV127. The value of CV902 of the connected module is
displayed.
4.12 USP – Uninterruptable Signal Processing
In combination with the optional energy storage, the intelligent USP circuit ensures that your
locomotive can run even over dirty track sections or dead frogs. The energy storage is not included
with this decoder and is installed separately in the vehicle.
Three terminal screws are provided on the decoder for the connection of the energy storage (e.g.
Power 1). See Fig. 3, p. 6.
4.13 RailCom
The GOLD maxi is equipped with the RailCom function. In addition to the locomotive address, other
data (e.g. speed, CV content) can be transmitted from the locomotive via the track back to the
system. The information sent is received by a RailCom detector and then displayed. Which data
the decoder is to send is set in CV28. Set Bit 4 in CV29 to enable the transmission function.
5 Signal stop and push-pull control with an external reed contact
The GOLD maxi has a connection for an external reed contact. The reed contact is installed at the
bottom of the locomotive. You can let your locomotive stop in front of a signal or operate in push-
pull operation with the help of a magnet installed in the track. Please see Fig. 4, p. 7 for the
connection of the reed contact.
Information GOLD maxi