Videotec MPX2CABL Bedienungsanleitung Seite 6

6.2 Cable tail connection
To avoid damaging the cables, insert them
one at a time using the cable input.
Consult the product use and installation
manual for all the operations for
opening and closure of the connections
compartment and the cable inputs.
Disconnect the terminals, assemble the cable
gland and fasten it to the conduit following the
instructions outlined in the manufacturer's manual.
Remove the cable input safety plug on the left (01).
Loosen the connection compartment cap (02).
02
Fig. 2
To facilitate assembly, loosen the cable gland
following the instructions provided in the
manufacturer's manual.
Insert the conductors using the cable input.
4
01
The cables must not be twisted during
cable gland tightening.
To maintain the product degree of IP,
apply sealant to the threads, in compliance
with IEC/EN60079-14.
Re-assemble the cable gland, fixing it to the
product, following the instructions provided in the
manufacturer's manual.
Re-connect the conductors to the terminals.
Connect the Ethernet cable, the signal and power
supply cables to the boards in the connections
compartment.
Consult the use and installation manual of
the product for further information.
Close the connections compartment.
MNVKMPX2C_2225_EN