Auto Set Fan; Software Version; Lcd Contrast; Factory Reset - Sentiotec Stp-Inface-T Bedienungsanleitung

3.5.10 Auto Set Fan

3.5.11 Software Version

3.5.12 LCD Contrast Setting

3.5.13 Factory Reset

3.5.14 Save and Exit

6
Auto fan turns on the fan once control goes to Off
Mode to dry out the steam room. Fan will remain on
01:15
for selected time. You may adjust the time from 0 - 24
hours with 15minute intervals. Auto fan is activated
only when the animated Auto button is displayed on
the screen.
Software version has two parts, Interface Software
Version and the Controller Board Version.
You can adjust the contrast of the display between 0
and 100.
Press the HeE RESET to remove heating element
error after checking or fixing the heating elements. If
steam generator's kW is changed, press reset button
instead.
Pressing the RESET button will revert all settings to
factory default. This is used when there is a
malfunction on the machine or you wish to clear
previous settings. Factory reset does not reset on
hours and kWh counters.
Once everything has been set, you may press SAVE
to save all the setup or ESC if you wish to abort the
settings.