Installing The Control Unit - Sentiotec Stp-Inface-T Bedienungsanleitung

2. Installing The Control Unit

Check the most suitable area to place your steam generator control. The control and
the steam generator should be accessible for the user and for maintenance. Do not
install the control unit inside the steam room! The cable connecting the control
unit and the steam generator is 7.5 meters long.
Never attempt to modify or fix the steam control. Contact your licensed technician or
your nearest service center for repair.
Before installation, main power supply of the generator must be switch off from the
circuit breaker.
Mount the control unit in the wall according to the specifications given below. Follow
the illustrations.
1
Metal
Casing
2
2
Run the Factory Reset after installing the steam
generator for the first time or after changing the
control panel. Refer to point 3.5.13.
152 mm
(Cut)
1
2
Control
Panel
Locks
Insert the metal casing
into the hole. Bend the
locks on the sides to
hold the casing still. If
not possible because of
a thick wall, screw the
casing into the wall.
3
Snap-in the control panel into
the metal casing to lock.
77 mm
For maintenance, pull out the
control panel using a flat screw
driver or similar.
4