Autodrain; Decalcifying; Blackout Memory; Temperature Scale - Sentiotec Stp-Inface-T Bedienungsanleitung

3.5.4 Autodrain

3.5.5 Decalcifying

3.5.6 Blackout Memory

3.5.7 Temperature Scale

3.5.8 Standby Temperature Setting

3.5.9 Auto Set Light

Bold outline means selected.
The autodrain is set to ON by default. For manual
drain, select OFF to deactivate the function.
When autodrain is ON, it will automatically drain the
water inside the steam generator tank after use. In
case of power interruption, it will continue to drain
when detecting a high water level in the tank.
Decalcifying function is very useful for maintenance.
This function requires autodrain.
Read more information on how to decalcify your
steam generator tank in page 15.
Active Blackout Memory restores control to its
previous state before power failure. For example, if
steam generator was on before power failure, the
steam generator will automatically continue from the
previous state.
You may set the temperature scale either Celsius or
Fahrenheit.
Steam room temperature will be maintained during
Standby Mode. Standby temperature can be set from
0 0
0 C to 45 C.
The light can be set as auto ON or OFF. When the
light is set to auto ON the light will switch ON when
the steam generator is in ON or Standby mode.
5