Introduction - Sentiotec Stp-Inface-T Bedienungsanleitung

1. Introduction

There are five different operation modes in the unit: OFF, ON, Standby, Easy
Mode and Drain. The user can easily switch between different modes making
the steam bathing more convenient.
To use the steam room, the control unit needs to be in ON Mode. In the ON
mode, the steam generator is producing steam and temperature in the steam
room is kept in preferred set temperature with occasional discharge of steam.
However, if the steam room is not used constantly, the generator can be set to
Standby Mode. During the Standby Mode, water and steam room are kept
warm with minimal energy consumption. The generator is able to produce
steam shortly after the unit is switched back to ON mode for the user's
convenience.
Indicators
Aroma ON (Animated)
- optional feature
Indicators
Steam ON (Animated)
Keylock is on.
Preset time is activated. Refer to point 3.5.14.
Heating element error icon shows if there is a problem with
the heating elements. Refer to Factory Reset point 3.5.13.
{
Light ON (Animated)
Dimmer - optional feature
Fan ON (Animated)
- optional feature
1