Description Of Symbols - Viking ME 443 Gebrauchsanleitung

Danger of electric shock!
Do not connect a damaged cable to the
mains and only touch a damaged cable
once it has been disconnected from the
mains.
Danger of electric shock!
Damaged cables, connectors and plugs,
or electric cables which do not conform
with regulations may not be used.
Only touch the cutting units (blades) when
the machine is disconnected from the
mains.
Always ensure that the power cables used
are adequately protected by a fuse.
Although the motor is
splashproof, do not use the
machine when it is raining or in
wet environments.
Only use extension cables that are
insulated against moisture for outdoor use
which are suitable for use with the
machine ( 11.1).
Keep the electric cable away from the
blade when mowing.
Detach electric cables at the plug and
socket and not by pulling on the electric
cable.
It must be noted that current fluctuations
can damage the machine when it is
connected to a power generator.
Only connect the machine to a power
supply that is protected by means of a
residual current-operated protective
device with a release current of a
maximum of 30 mA. Your electrician can
provide further information.
For reasons of electrical safety, the electric
cable must always be correctly installed on
the handlebar.
36
4.9 Disposal
Ensure that old machines are properly
disposed of. Render the machine
unusable prior to disposal. In order to
prevent accidents, ensure that you remove
the power supply cable or the electric
cable to the motor.
Risk of injury due to the cutting tool!
Always store an old machine in a safe
place prior to scrapping. Ensure that the
machine and the cutting tool are kept out
of the reach of children.

5. Description of symbols

Caution!
Read the instruction man-
ual before initial use.
Risk of injury!
Keep other persons out of
the danger area.
Risk of injury!
Beware of the sharp mowing
blade. The mowing blade
runs on for several seconds
after switching off
(motor/blade brake). Before
performing any work on the
cutting tool, before carrying
out maintenance and clean-
ing work, before checking
whether the electric cable is
entwined or damaged, or
before leaving the machine
unattended, switch off the
motor and disconnect the
plug.
Danger of electric shock!
Keep the electric cable
away from the cutting tool.
ME 443:
Switch on the motor.
ME 443 C:
Switch on the motor.
ME 443 C:
Switch off the motor.
0478 121 9920 D - EN