Assembling The Tool; To Bleed The Tool - Avdel T51 Betriebsanleitung

M a i n t e n a n c e
A s s e m b l i n g t h e To o l
Examine and replace all worn parts. Fit a new Service Kit 29.
•
Apply hydraulic oil to all 'O' rings, back-up rings and contact surfaces before fitting.
•
Fit new 'O' Rings 4, 7 and Back-up Rings 3, 6 to the Gland 5.
•
Fit 'O' Ring 16 and Back-up Rings 15 to Piston 13.
•
Fit new 'O' Ring 12 and Back-up Ring 11 into the Piston 13 and secure with the Screw 10 using a 6 mm Allen Key.
•
Insert the Ejector Pin 14 into the Piston 13 ensuring it protrudes at the front of the piston.
•
Install the Piston 13 into the Cylinder 19.
•
Install the Gland 5.
•
Install the Anvil Retainer 2.
•
Re-clamp the Grub Screw 18 using a 5 mm Allen Key.
•
Refit the Collet Adaptor 9.
•
Align the hole with the Keyway.
•
Insert the Nylon/Brass Plug 8.
•
Bleed the Tool.

To Bleed the Tool

•
Couple the short Tool Hoses directly onto a HydraPac or compatible hydraulic power source.
Note: Do not use long extension hoses as these will prevent the air from escaping into the HydraPac.
•
Plug in a Hydrapac Test Trigger.
•
Position the Tool so that the piston rod side faces vertically up.
•
Cycle a few times.
•
Reverse the vertical position and cycle again.
Item numbers in bold refer to the general assembly drawing and parts list on pages 10-11.
9