Operating Instructions - Avdel T51 Betriebsanleitung

P u t t i n g i n t o S e r v i c e
O p e r a t i n g I n s t r u c t i o n s
®
To Install an Avdelok Fastener
•
Check work and remove excessive gap. (Gap is the space between components of the Joint. Gap is excessive if not enough
pintail sticks through the collar for the nose assembly jaws to grab onto.)
•
Put Avdelok ® fastener into hole.
• ®
Slide Avdelok collar over pin. (The bevelled end of the collar must be towards the nose assembly and tool.)
•
Push nose assembly onto pin until the nose assembly anvil stops against the collar. Tool and nose assembly must be held at right
angles (90°) to the work.
•
Depress tool trigger switch to start installation cycle.
•
When the forward motion of the nose assembly anvil stops and the pintail breaks off, release the switch. The tool will go into its
return stroke and push off the installed fastener. At the end of the return stroke the jaws will release the expended pintail which
can be removed by tilting the tool down.
•
Once the expended pintail has been ejected, the tool and nose assembly is ready for the next installation cycle.
DO NOT ATTEMPT TO BREAK OFF A PINTAIL WITHOUT THE INSTALLATION OF A COLLAR AS THIS WILL CAUSE THE
UNSECURED PORTION OF THE AVDELOK
CAUTION
®
PIN TO EJECT FROM THE NOSE AT A HIGH SPEED AND FORCE.
7