Servicing The Tool; Daily Servicing; Weekly Servicing - Avdel 74101 Betriebsanleitung

Servicing the Tool

Regular servicing should be carried out and a comprehensive inspection performed annually or every 200000 cycles,
whichever is soonest.
The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate
personnel. The operator should not be involved in maintenance or repair of the tool unless properly trained.
D A I LY S E R V I C I N G
•
Daily, before use or when first putting the tool into service, pour a few drops of clean, light lubricating oil into the air inlet
of the tool if no lubricator is fitted on air supply. If the tool is in continuous use, the air hose should be disconnected from
the main air supply and the tool lubricated every two to three hours.
•
Check for air leaks. If damaged, hoses and couplings should be replaced by new items.
•
If there is no filter on the pressure regulator, bleed the air line to clear it of accumulated dirt or water before connecting
the air hose to the tool. If there is a filter fitted, drain it.
•
Check that the nose assembly is correct.
•
Inspect the drivescrew in the nose assembly for wear or damage. If there is any, renew.
W E E K LY S E R V I C I N G
•
Fully dismantle and service the nose assembly (see instructions page 10).
•
Lubricate the clutch spring with high pressure grease (eg. Shell Alvania EPI).
•
Check the clutch torque setting (see clutch adjustment procedure page 17).
•
Check for air leaks in the air supply hose and fittings.
I M P O R T A N T
13