Putting Into Service; Air Supply; Operating Procedure - Avdel 74101 Betriebsanleitung

Putting into Service

A I R S U P P LY
All tools are operated with compressed air at an optimum pressure of 5.5 bar. We recommend the use of pressure regulators
and automatic oiling/filtering systems on the main air supply. These should be fitted within 3 metres of the tool (see diagram
below) to ensure maximum tool life and minimum tool maintenance.
Air supply hoses should have a minimum working effective pressure rating of 150% of the maximum pressure produced in the
system or 10 bar, whichever is the highest. Air hoses should be oil resistant, have an abrasion resistant exterior and should
be armoured where operating conditions may result in hoses being damaged. All air hoses MUST have a minimum bore
diameter of 6.4 millimetres or 1/4 inch.
Read servicing daily details page 13.
O P E R A T I N G P R O C E D U R E
When placing Standard Nutserts, lubricate the drive screw of the tool every 25 placings. This is best
achieved by wiping the drive screw with a sponge soaked with STP Lubricant part number 07992-00013.
OPTION 1
•
Ensure that the correct nose equipment is fitted.
•
Connect the tool to the air supply.
•
Place the insert into the prepared hole of the application.
•
Locate the drive screw of the tool into the insert.
•
Operate the lever. The drive screw will screw into and
collapse the insert, then automatically reverse out.
8
STOP COCK
(USED DURING MAINTENANCE
OF FILTER/REGULATOR
OR LUBRICATION UNITS)
8
LUBRICATOR PRESSURE REGULATOR
(DRAIN DAILY)
I M P O R T A N T
OPTION 2
•
Ensure that the correct nose equipment is fitted.
•
Connect the tool to the air supply.
•
Screw the insert lip first onto the drive screw of the tool.
•
With the insert on the tool, locate it into the prepared
hole of the application.
•
Operate the lever. The drive screw will screw into and
collapse the insert, then automatically reverse out.
TAKE OFF POINT
FROM MAIN SUPPLY
MAIN SUPPLY
DRAIN POINT
AND FILTER