Mounting The Projector; Inserting The Projector - Kindermann Compact 80 Installationsanleitung

Safety instructions for adjusting the stop positions
1 . The switches and controls must not enable simultaneous up and down commands . This would damage the unit .
Only use mechanical or electrical switches .
2 . There must be more than 0 .5 seconds between an up and down command .
3 . Avoid overheating during test drives and in normal operation, i . e . the motor should not work uninterruptedly for more
than 4 minutes . Overheating may trigger off the inbuilt thermal switch . In such a case, please wait at least 10 minutes
until the unit is ready for use again .
4 . Check whether the two towing ropes have the same length and are wound up tightly and evenly on the shaft of the
motor .
5 . Make sure that the projector is brought in upward position only after it has been switched off and cooled down .
That means: After the lamp is off and the projector signals STANDBY, you must wait at least 5 minutes until the lift can
be raised to stop position 1 .
If the unit is automatically operated by a media control system, this has to be programmed correspondingly .

Mounting the projector

Prerequisites of the projector:
Three or four drill-holes (M3, M4, M5 or M6) on the bottom, distance between the drill-holes between 75 and 370 mm .
Max. weight: 20 kg, max. dimensions: 35 x 50 cm
Mounting with only 3 carrying arms is possible .
Supplied with 4 sets of screws with washers M3, M4, M5, M6 .
Required tools:
1 screw driver + Allen key No . 3
2 spanner 10 mm

Inserting the projector

The four carrying arms and the distance bolts are attached to the projector holder
9
stration 1) and can be put back (illustration 2) . Just loosen the two screws
them again .
With the help of the distance bolts you can even out different levels of the drill-holes in the projector bottom .
Loosen the centre screw
b
Put your projector upside down on a soft surface (illustration 3) .
Find out the proper set of screws
distance bolts . Use the suitable washers on both sides .
Fasten the centre screw of the carrying arms .
b
Hang the pre-mounted unit into the projector holder
Secure the connection by fastening the two screws through the slots of the cross bar .
Adjustment of the projector
1 . The projector hanging from the cross bar can be easily rotated resp . tilted by about ± 20° .
If the position of the projector in relation to the screen is correct, the screw of the projector holder
a spanner .
2 . The projector holder is located in the centre of the cross bar
required (see illustration) .
To this effect loosen the screw of the projector holder . Make sure that the screws of the carrying arms remain accessible
when shifting the holder .
3 . After loosening the four screws the cross bar
provided the height of the false ceiling allows it resp . the projector would otherwise not fit onto the cross bar
(illustration 4).
Illustration 1
a
7
of the carrying arms with 2 spanners 10 mm (illustration 2) .
that fit into the drill-holes of your projector and fasten the carrying arms with the four
10
8
can be taken off to the left or to the right or can be rotated if required,
7
Illustration 2
8
b
9
through the slots of the cross bar, resp . fasten
a
on the cross bar .
7
and can be shifted to the left and right resp . to the rear if
7
Illustration 3
and can be taken off sidewards (illu-
8
can fastened with
8
Illustration 4
15