Automatically Tuning The Tv Using The Remote Control - Sony KV-21FX20D Bedienungsanleitung

First Time Operation - Basic Presetting

Automatically Tuning the TV using the Remote Control

You need to tune the TV to receive channels (TV Broadcast). By following the instructions below, this TV automatically
searches and stores all available channels for you.
After having selected the language, a new menu appears automatically on the TV screen asking you to automatically tune
the TV. However, if you need to change or repeat the tuning afterwards (e.g. when you move house), select the menu
AUTO PROGRAMME in the
to the section "Automatically Tuning the TV using the TV buttons" of this instruction manual.
1 2 3
4 5
6
7 8 9
0
MENU
K
PROGR
RM 887
S
10
First Time Operation - Basic Presetting
(SET UP) menu and proceed in the same way as described below in step 1 or, please refer
1
Press the OK button on the remote control to select YES.
A new menu appears automatically on the screen asking you to
check that the antenna is connected.
2
Confirm that the antenna is connected and then press the OK
button.
The automatic tuning starts and the message "Searching..." flashes
on the screen.
This procedure could take some minutes.
When the automatic tuning is finished, the Programme Sorting menu
appears on the TV screen.
Notes: • To stop the automatic tuning, press the MENU button.
• If you stop the automatic tuning by pressing the MENU
button, the Programme Sorting menu does not appear
automatically on the TV screen.
Do you want to start
automatic tuning?
Do you want to start
automatic tuning?
YES
YES
NO
NO
Please confirm that
antenna is connected
CONFIRM
AUTO PROGRAMME
PROGRAMME: 01
B/G
SYSTEM:
CHANNEL: C 21
Searching...
PROGRAMME SORTING
PROGRAMME: 01 03
CONFIRM
Select Channel: PROGR
Select new position:
Confirm:
Exit:
MENU