Styling - Curling; Cleaning And Care - Silvercrest SBHS 50 B1 Bedienungsanleitung

Styling – curling
For styling, the hair should be dry or slightly damp and free of styling products .
This does not apply to products that protect the hair from the effects of heat .
The appliance is heated up to the desired level and the hair is combed and free
of knots .
■ Twist the end of the strand around the styling brush 2 and then roll the styling
brush 2 upwards towards the hair roots so that the complete strand is rolled
around the styling brush 2 . Ensure that you touch the appliance only on the
holding tip 1 and the handle . The styling brush 2 gets very hot .
■ Wait for 8–15 seconds (depending on the length and thickness of the hair) .
■ Press the curl release button 3 and simultaneously pull the appliance out of
the strand in a downwards direction . The styling brush 2 turns so that the
strand can be unrolled easily .
■ Proceed the same way with the other strands .
■ Once you are finished styling, turn the level switch 6 to "0" and pull out the
plug from the mains power socket .

Cleaning and care

RISK oF eLeCTRIC SHoCK
► Before cleaning the appliance, always pull out the plug from the mains
power socket . There is a risk of electric shock!
WARNING! RISK oF INjURy!
► Allow the appliance to cool fully before cleaning it . Risk of burns!
CAUTION – PrOPErTy dAmAgE!
► Do not use any aggressive, abrasive or chemical cleaning agents!
These could damage the upper surfaces of the appliance .
■ Remove any hair or lint from the bristles of the styling brush 2 with your
fingers .
■ Clean the appliance only with a lightly moistened cloth .
■ Allow the appliance to dry completely before reuse or before putting it away .
SBHS 50 B1 GB │ IE │ NI 9 ■
│