Genius ROTORAZER 8 in 1 Übersetzung Der Originalanleitung Seite 14

Hold the top cover by hand and tighten the
screw with the Nut driver (8) (Image R).
2- To remove simply reverse the steps.
Assembling the Anti-collision Frame
To install the anti-collision frame (9), align the
edges with the cover's frontal holes, as shown
on Image N.
Assembling the Hand Support
To assemble the Hand Support (4), insert the
handle into the rod and adjust it at the desired
position and height (Image O), and screw the
nut and tighten it to keep it fixed.
Adjusting the telescopic pole
To adjust the height of the telescopic pole, just
push the adjustment button (Image P) and re-
lease it when desired height is reached.
Adjusting the cover head
To adjust the cover head of the machine to
desired cutting angle, just press the machi-
ne head button to move the head up to 90
degrees (Image Q). There are three angles
available.
Technical Specifications:
Li-Ion Battery: 3.7V 1500mAh, 5pcs battery
inside
Voltage: 20Vd.c.
Maximum speed (/min): 10000
Load speed (/min):9000
Cutting diameter: 150mm
Charging output (A): 0.5
Charging time: Around 180 min
Working time: Around 60-90min, depending on
work environment
4. CLEANING AND MAINTENANCE
To clean your ROTORAZER® 8-IN-1, simply
slide a damp microfiber cloth gently over the
surface to remove dust and dirt.
DO NOT use bleach or any other corrosive
product on the product.
Make sure you store the product away from
any source of fire or heat.
5. WARRANTY
This product is covered by a warranty against
manufacturing defects subject to the time pe-
riods stipulated by the legislation in force in
each country.
This warranty does not cover damage resul-
ting from inadequate use, negligent commer-
cial use, abnormal wear and tear, accidents or
improper handling.
14
Australia & New Zealand only
This product has the benefit of certain Con-
sumer Guarantees. These are prescribed by
the Australian Consumer Law & the New
Zealand Consumer Guarantees Act 1993
both of which provide protection for consu-
mers. There is no express warranty for this
product in Australia or New Zealand. The
above paragraph refers to other countries.
CAUTION
DISPOSAL OF MATERIALS
A symbol of a crossed-out wheeled bin
means you should find out about and
follow local regulations about disposing
of this kind of product.
Do not dispose of this product as you would
other household waste.
Dispose of this product in accordance with the
corresponding local regulations.
Electrical and electronic appliances contain
hazardous substances that can have harmful
effects on the environment and/or human
health and should be recycled properly.
Made in China