VEVOR RTD-8L Bedienungsanleitung Seite 6

1. Please fold or roll up the damp or pre-moistened towels but not soaked
ones into the wire basket of hot towel warmer. Try to wring out the water
several times to shorten the heating time.
2. 100% cotton dry towels could be put as well but not any other cloths
which couldn't bear this high temperature, and keep it within less than 2
hours heating. Please keep the towel away from the inner wall of warmer.
3. Do not overload the wire basket or directly place towels into the towel
warmer.
4. Close the door firmly and press the Power button to turn on. The
indicator near the switch will be on to show that the towel cabinet has
started heating.
5. It will take approximately 1.5 to 2.5 hours, depending on the number of
towels placed inside the cabinet. While keeping the cabinet door closed,
the temperature inside the cabinet will rise to the set temperature and will
automatically remain at this temperature. Do not open the cabinet door
while the towels are being heated.
6. When you want to add more towels, simply press the power button. The
heating process will restart. When the temperature reaches the limit, the
thermostat will automatically stop working. You can rest assured to keep it
in the on position.
7. If desired, press the UV button to turn on
system. The indicator near the switch will be on to show that the UV light is
working. Wait 30 minutes for the sterilization process to complete.
8. Whenever you want to open the door, please first turn off the power with
the indicator light off. Stay a safe distance from the cabinet door opening to
avoid being burned by high-temperature steam from the cabinet. Remove
towels with tongs or heat-resistant gloves.
9. Towels may be too hot to apply immediately, and caution should be
used before applying to the face or body.
OPERATION
EPA-registered UV sterilization
5