VEVOR RC1000 Bedienungsanleitung Seite 13

Trouble Shooting
The device does not discharge:
(1) Check whether the output buttons are activated;
(2) Check whether the total output power exceeds the rated output power;
(3) Check the battery power indicator to confirm whether the power supply is
sufficient;
(4) If the device cannot be discharged after it is discharged for longtime, please
wait for several hours and try again, it may enter the over-temperature protection.
The device can not be charged:
(1) Confirm that the wall plug power adapter's cord is inserted fully into the DC
Input.
(2) Confirm whether the charging cable is the special charging cable provided by
us. If the input does not comply with the requirements located in the general
specifications section, the low watt range 0 % to 10 %may be displayed on the
LCD.
(3) If the device cannot be charged immediately after it is discharged,please wait
for several hours and try again, it may enter the over-temperature protection.
Note
A photovoltaic panel as input for charging the internal battery shall be provided
with an inverter and/or a charge controller in accordance with UL 1741 or UL
62109-1; The external power supply shall be a power source in accordance
with the Standard UL 60950-1 and CAN/CSA C22.2 No. 60950-1, or UL 1310
and No. 1,CAN/CSA C22.2 No. 223, or No.1,CAN/CSA C22.2 No. 223;
A vehicle adapter that complies with the enclosure and input contacts
requirements
in the Standard for Vehicle Battery Adapters, UL 2089, and Power Supplies,
CAN/CSA C22.2 No. 107.1.The connector plug shall incorporate a fuse or
other protective device having a current rating not greater than 15 A.
INSTRUCTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS.
IMPORTANT SAFETY INSTRUCTIONS
- 12 -