RENPHO R-D001R Bedienungsanleitung Seite 10

2. Press the
default Mode and Intensity in
3. Press the
15, 20, or 30 minutes. The timer will re-time each time
you press the Time Button.
4. Press
feet, Fore feet or Rear feet area.
5. Press
1/2/3/4.
6. Press the
L/M/H/OFF.
7. Press the
or select Full (Bottom+Instep), Instep or Bottom heating
area.
Note:
A: Heating, Kneading and Air pressure function can work
independently.
B: Each press is accompanied by a beep sound and
corresponding indicator light (When off, the LED goes
out).
C: If none of the Heating, Kneading and Air pressure
function is working, the Time and Power button indicator
lights are on, and the massager will enter the standby
state if there is no further operation within 10 seconds.
8. The foot massager fits up to US Men's size 14 (EU Men's
size 48.5 ).
9. Removable mesh: Unzip to remove and clean
Button to turn on the massager. Check the
Button to switch the auto-off time among
to turn ON/OFF the Mode function or select Full
Button to adjust the Air Intensity among
Button to adjust the Knead Intensity among
Button to turn ON/OFF the heating function
Button Introduction
EN-07
chart.