Inhaltsverzeichnis
Werbung
10.1 Maintenance and repairs measures
•
Substitute missing parts
•
Exchange broken jumping beds
•
Exchange any springs which are overstretched or broken.
To find out whether a spring is overstretched just have a
look at the spring body and see whether it is equally
twined. The spring is also broken when you stretch it and
afterwards it does not recover its original form.
•
To unhinge the steel springs, please use the mounting
Mounting tool
10.2 Maintenance and repairs cycles
TYPE OF INSPECTION
Normal visual inspection
Operational inspection
Annual main inspection
Hinging or unhinging the steel springs with
the mounting tool
FREQUENCY
•
Monthly, if the Kids Tramp is used occa-
sionally
•
Weekly, if the Kids Tramp is used quite
a lot
•
Daily, if the Kids Tramp is used very often
or if there is a big risk of vandalism
•
Every three months if the Kids Tramp is
used occasionally, every month if it is used
a lot
•
Annually
tool which is delivered together with the trampoline.
Unhinge the springs first at the jumping bed side and
then you can put them off at the trampoline frame side.
To hinge the springs again it is important that the spring
ears point downwards. Fix the single spring at the frame
side first and then at the jumping bed side. For doing so
use the mounting tool. It is easier to hinge the steel
springs at the jumping bed side if you put up the anchor
bars of the bed.
Hinging or unhinging the steel springs with
the mounting tool
CONTENT
Visual control of the jumping bed, impact pro-
tection and number of springs.
Check whether the Kids Tramp and its sur-
roundings are clean and whether there are any
sharp eges, etc.
Additionally to the visual control
•
Control whether the pit has been filled up
with grit or anything else
•
Control whether there are any defects
caused by corrosion
•
Control whether there are any missing
parts
•
Control whether there has been excessive
wearout
General control whether the Kids Tramp is fool-
proof. That's why additionally to the visual and
operational control you have to check whether
•
the jumping bed is hinged properly
•
the frame has any fracture or other defect
•
the steel springs are broken or overstretched
•
the spring ears point downwards both at the
jumping bed side and at the frame side
11
Werbung
Inhaltsverzeichnis
