Product Description And Specifications; Intended Use - Bosch GGS 28 C Professional Originalbetriebsanleitung

OBJ_BUCH-1269-003.book Page 19 Thursday, December 16, 2010 4:05 PM
Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can
cause kickback.
Safety warnings specific for polishing
operations (GGS 8 CE)
Do not allow any loose portion of the polish-
ing bonnet or its attachment strings to spin
freely. Tuck away or trim any loose attach-
ment strings. Loose and spinning attach-
ment strings can entangle your fingers or
snag on the workpiece.
Safety warnings specific for wire brushing
operations (GGS 8 CE)
Be aware that wire bristles are thrown by
the brush even during ordinary operation.
Do not overstress the wires by applying ex-
cessive load to the brush. The wire bristles
can easily penetrate light clothing and/or
skin.
Allow brushes to run at operating speed for
at least one minute before using them. Dur-
ing this time no one is to stand in front or in
line with the brush. Loose bristles or wires
will be discharged during the run-in time.
Direct the discharge of the spinning wire
brush away from you. Small particles and ti-
ny wire fragments may be discharged at high
velocity during the use of these brushes and
may become imbedded in your skin.
Additional safety warnings
Wear safety goggles.
Use suitable detectors to determine if utili-
ty lines are hidden in the work area or call
the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Bosch Power Tools
Release the On/Off switch and set it to the
off position when the power supply is inter-
rupted, e. g., in case of a power failure or
when the mains plug is pulled. This prevents
uncontrolled restarting.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Product Description and
Specifications
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is designed for grinding and de-
burring metal using corundum grinding tools, as
well as for working with sanding wheels.
GGS 8 CE: The machine is additionally intended
for brushing and polishing metal.
3 609 929 C06 | (16.12.10)
English | 19