Waterdrop WD-15UD-RS Installationsanleitung

Undersink Water Filtration System
WD-15UD-RS | Installation Instructions
Installation of the filter system
Step 1: Fix the filter head and the filter
1. Paste the assistant label to finish drilling. (Note: Mount the water filter at
least 2 inches higher than the ground for easier filter change.)
2. Install the screw and reserve enough space to hang the filter.
3. Hang the filter system on the screw.
Step 2: Connect the RO system.
1. Power off the RO system and turn on faucet to release pressure.
2. Place a rug under the outlet pipe of RO system. Cut the RO system 1/4" outlet tube at the adequate
position (Figure 1).
Note: A small amount of water may flow out of the cut.
3. Insert both ends of the cut pipe into the inlet and outlet of the filter connector respectively, to
ensure that the pipe is fully inserted into it (Figure 2).
Note: Do not put the cut pipe in a reversed direction.
4. Turn on the power of RO system and faucet to let it dispense water. Observe that whether there is
water leakage at the connecting point. Please keep the faucet open and rinse for 5 minutes before
using (Figure 3).
Figure 1
Note: The life time of the post filter is 3 months. You should manually record when the filter should
be replaced since there's no intelligent reminder. If you have a large consumption of water, the
filter should be replaced in advance.
Manufacturer Technical Support
Tel: 1-888-352-3558 (U.S.)
E-mail: service@waterdropfilter.com
Cut Cleanly
and Squarely
Inlet hose
Figure 2
Outlet hose
Figure 3
Outlet
Inlet
RO
SYSTEM
Made in China V040
Qingdao Ecopure Filter Co., Ltd.