Charging Indicator Light - Retevis Matetalk E1 Bedienungsanleitung

Charging indicator light

Indicator light display
Red light on
Red and green lights Alternate flash
Red light flash
Green light on
Installing and removing the antenna
1.Rotate the antenna clockwise until it is tightened.
2.To remove the antenna, rotate it counterclockwise.
Note:·Do not over tighten the antenna to avoid damaging the connector.
·When installing the antenna, do not grip the top of the antenna. Grasp the base tightly and
rotate it.
·Do not hold or wrap the antenna with your hands to avoid accidental operation of the radio.
·Do not send without an antenna.
Install and remove the battery pack (in the safe zone，NOT in any area with a potentially
hazardous or explosive atmosphere)
1. When installing the battery pack, align the two positioning slots at the bottom of the
battery pack with the corresponding positions of the plastic square holes at the bottom of the
radio, and then gently press the battery pack downwards until a "click" sound is heard.
2 . When removing the battery pack, please first confirm that the radio is turned o , then
gently push the battery button of the radio upwards. When the user hears a "click" sound, the
battery will pop up and remove the battery pack.
Status
Charging
Battery charging capacity greater than 90%,
switch to slow charging
Battery short circuit phenomenon or battery low
voltage phenomenon
Charging completed
03