Getting Started - Ctek Nxt 5 Bedienungsanleitung

GETTING STARTED

1
Connect the battery clamps to the 12V battery
Note: Refer to the vehicle / battery manufacturers
guide for terminal connection points.
Some vehicles may have positively grounded batteries, so the
U Terminal connectors may be required at this stage (fig 1).
2
Connect the charger to the wall socket.
The power indicator will illuminate green to indicate that the
mains cable is connected.
If the battery clamps are incorrectly connected, the error
indicator will illuminate red.
NOTE! If the battery clamps are incorrectly
connected, the reverse polarity protection will ensure that
the battery and charger are not damaged.
3
Press the MODE-button to select charging program.
4
Follow the display through the automatic charging process.
The battery is fully charged when the CARE lamp is
illuminated.
Stop charging at any time by disconnecting the mains
cable from the wall socket.
© CTEK SWEDEN AB
(fig 2). A. ERROR INDICATOR - Illuminates RED when an issue has been
detected. Refer to troubleshooting for help.
B. POWER INDICATOR - Illuminates GREEN when the Charger is
connected to a power outlet.
C. MODE BUTTON - This allows you to cycle through the required
program to suit your battery. Settings are made by pressing the
MODE-button as shown on 'Interface' page.
After two seconds the charger activates the selected program.
The selected program will be restarted next time the charger is
connected.
D. STATUS INDICATORS - The built-in 8 step programme tests
the battery condition and revives, charges and maintains to ensure
maximum battery life and performance.
E. LITHIUM - Use for LITHIUM* batteries.
F. MOTORCYCLE PROGRAM - Suitable for smaller
batteries.
G. CAR PROGRAM - only for lead-acid batteries.
H. AGM - Suitable for AGM batteries.
option to restore and recondition lead-acid
I. RECOND -
batteries.
WARNING! Do not apply RECOND mode on the following
types of batteries: - Lithium: LiFePO
UNDER VOLTAGE PROTECTION
To use the manual "wake up", press and hold the Mode button for
approximately 10 seconds
batteries.
WWW.CTEK.COM
WHAT'S IN THE BOX
NO. ITEM
1
2
3
, Lead Acid: GEL or AGM 4
4
5
6
* Supply plugs may differ to suit your wall socket
** Packaging elements may vary subject to the model
to revive seemingly dead lithium
*** Check the provision of your municipality for the management of waste
Please read all of the instructions detailed in this
user manual carefully before use.
LITHIU M *
1
4 3
5 6
PACKAGING CODE
MATERIAL OF
USED** MATERIAL
NXT5 Transparent film PP5
Mains Adapter Cable tie 92
Charge clamps Cable tie 92
U Terminal Cable tie 92
User manual Paper PAP22
Gift box Cardboard PAP20
NXT5 | USER MANUAL | 4
2
MATERIAL
CATEGORY
***
Plastics
Composite
Composite
Composite
Paper
Paper