Berner BACJS-18V Bedienungsanleitung Seite 29

Switching On and Off (fi g. H)
For safety reasons your tool is equipped with a safety
lock.
• To unlock the tool, release the safety lock (2).
• To run the tool, press the variable speed switch (1).
The pressure exerted on the variable speed switch
determines the tool speed.
• To stop the tool, release the switch.
• To lock the tool in off position, activate the safety
lock.
WARNING: After using the tool for an
extended period on low speed settings, run
it for approx. 3 minutes on maximum no-load
speed.
Sawing in Wood
• If necessary, draw a cutting line.
• Switch the tool on.
• Hold the tool against the workpiece and follow the
line.
• For sawing parallel to the edge of your workpiece,
install the parallel fence and guide your jigsaw
along the workpiece a shown in fi gure I.
Sawing in Wood Using a Pilot Hole
• If necessary, draw a cutting line.
• Drill a hole (Ø min. 12 mm) and introduce the saw
blade.
• Switch the tool on.
• Follow the line.
• For cutting perfectly round shapes, install the
trammel bar and set it to the required radius
(fi g. J).
Sawing up to a Projecting Edge (fi g. K)
• Using a conventional blade, cut up to the projected
edge.
• Finish off the cut using a fl ush cutting blade.
Dust Extraction (fi g. G)
• When the tool is used indoor for extended periods
of time, use a suitable dust extractor designed
in compliance with the applicable Directives
regarding dust emission.
Sawing in Metal
• Mount an appropriate saw blade.
• Proceed as described above.
CAUTION: Use a cooling lubricant (cutting oil)
to prevent overheating of the saw blade or the
workpiece.
MAINTENANCE
Your Berner power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of serious
personal injury, turn tool off and
disconnect battery pack before making
any adjustments or removing/ installing
attachments or accessories. An accidental
start-up can cause injury.
The charger is not serviceable. There are no
serviceable parts inside the charger.
Lubrication
LUBRICATING THE GUIDE ROLLER (FIG. C)
• Apply a drop of oil to the guide roller (7) at
regularintervals to prevent jamming.
Cleaning
WARNING: Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust
mask when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth
dampened only with water and mild soap.
Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the
charger from the AC outlet before cleaning.
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any
cleaning solutions.
29
E N G L I S H