Unpacking; Connecting; Startup - BELINEA 10 19 20 Bedienungsanleitung

UNPACKING

Carefully lift the monitor out of the packaging and make
sure that all components are included (see fig. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
To set up the device, you must fit the monitor base toge-
ther. You can adjust the height of the base. When the
base of the monitor is extended, you can tilt the monitor
90° (Pivot function).

CONNECTING

To connect the monitor to your PC ........................
1. Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the monitor and
the PC (see figure 2a).
Figure 2a. Connecting the monitor to the PC
Connecting the audio cable .....................................
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio input
$
connector of the monitor ( in fig. 3) and the other end to
the Line-Out connector of the computer.
Headphone connector .............................................
If you own headphones, you may connect them to the
monitor's headphone connector (

STARTUP

1. First start your PC and then turn on your Belinea
monitor using the power switch (
#
indicator ( in fig. 4) should light up green.
2. Adjust the image to meet your requirements (see the
following sections "Basic Setup" and "Image settings
using the OSD menu").
Signal cable
%
in fig. 3).
"
in fig. 4). The status
Figure 1. Monitor with swivel base
3. If you have a graphic card with a digital DVI-D
connector (24-pin socket), then connect one end of
the DVI-D cable (optional) to the DVI-D connector of
your monitor (see fig. 2b), the other end to the
computer.
Figure 2b. Connection via the DVI-D interface
To connect the monitor to the power source ........
Connect the separate power cable (
monitor and a grounded outlet.
Figure 3. Connecting the monitor to the power source
3. If there is no image displayed on the monitor, consult
the section "Troubleshooting".
ENGLISH
Power cord
Audio cable
VGA cable
DVI-D cable
(optional)
DVI-D cable
!
in fig. 3) to the
Operating Instructions - 11