Unpacking; Connecting; Startup - BELINEA 10 17 10 Bedienungsanleitung

UNPACKING

Carefully lift the monitor out of the packaging and make
sure that all components are included (see fi g. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
± Assembling the monitor base ................................
1. To attach the base, place the monitor face down on
a fl at surface.
2. Fold the stand upwards and slide the base onto the
stand until it clicks into place.
3. Then fold out the assembled base completely so that
you can place the device upright.

CONNECTING

± To connect the monitor to your PC .........................
1. Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the monitor and
the PC (see fi g. 2).
AC-IN D-SUB
Figure 2. Connecting the monitor to the PC

STARTUP

1. First start your PC and then turn on your Belinea
monitor using the power switch (
status indicator ( in fi g. 4) should light up green.
2
Signal cable
Figure 3. Connecting the monitor to the power source
± Connecting the audio cable ....................................
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio
input connector of the monitor (
end to the Line-Out connector of the computer.
± To connect the monitor to the power source ........
Connect the separate power cable (
monitor and a grounded outlet.
± Headphone connector .............................................
If you own headphones, you may connect them to the
monitor's headphone connector (
2. Adjust the image to meet your requirements (see the
in fi g. 4). The following sections "Basic Setup" and "Image settings
using the OSD menu").
3. If there is no image displayed on the monitor, consult
the section "Troubleshooting".
Power cord
MENU SELECT
AUTO VOLUME MUTE
Figure 1. LCD Monitor
AC-IN D-SUB
in fi g. 3) and the other
in fi g. 3) to the
in fi g. 3).
Operating Instructions - 11
ENGLISH
VGA cable
Audio cable
3
1