Unpacking; Connecting; Startup - BELINEA 10 80 35 Bedienungsanleitung

UNPACKING

Carefully lift the monitor out of the packaging and make
sure that all components are included (see Figure 1).
Assemble the tilt/swivel base to the monitor (see the
next section).
Save the original box and packing material in case you
have to ship or transport the monitor.
➧ Assembling the tilt/swivel base ...............................
1. Place the monitor screen down on a soft surface
(pillow, blanket or similar object).
2. Align the latches of the tilt/swivel base with the
openings on the bottom of the monitor and push the
base forward until it locks into place.

CONNECTING

➧ To connect the monitor to your PC .........................
1. Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the monitor and
the PC (see fi gure 2a).
Figure 2a. Connecting the monitor to the PC
➧ To connect the monitor to the power source .........
1. Connect the separate power cable to the monitor and
a grounded outlet (see fi gure 3).

STARTUP

1. First, turn on your PC, and then turn on your Belinea
monitor. The status indicator (see
should light up green.
2. Adjust the image to meet your requirements (see the
following sections "Image settings using the OSD
menu" and "OSD Menu Functions").
➧ Disassembling the tilt/swivel base ..........................
1. Push the locking tabs at the back of the base inward
while pulling the base backward (toward the monitor's
back). Now the base should come off easily.
3. Alternately, you can connect a BNC signal cable to
the monitor as required (BNC cable not supplied).
Signal cable
Figure 2b. Monitor connected via the BNC cable
Figure 3. Connecting the monitor to the power source
3. If there is no image displayed on the monitor, consult
in fi gure 4) the section "Troubleshooting".
Power Cord
Figure 1. Monitor with Tilt/Swivel Base
Operating Instructions - 11
ENGLISH
Signal Cable