Safety Instructions; General Safety - Waeco CoolMatic CRP-40 Bedienungsanleitung

CoolMatic CRP-40
Note
I
Supplementary information for operating the device.
➤ Action: This symbol indicates that action is required on your part. The re-
quired action is described step-by-step.
✓ This symbol describes the result of an action.
fig. 3 1, page 4: This refers to an element in an illustration. In this case,
"item 1 in figure fig. 3 on page 3".
Please also observe the following safety instructions.
2

Safety instructions

WAECO International will not be held liable for claims for damage resulting
from the following:
Damage to the device resulting from mechanical influences and excess
voltage
Alterations to the device made without the explicit permission of WAECO
International
Use for purposes other than those described in the operating manual
2.1

General safety

Have a trained technician perform the installation in wet rooms.
a
Do not operate the appliance if it is visibly damaged.
This appliance may only be repaired by qualified personnel. In-
adequate repairs can cause considerable hazards.
If you device should need repairing, please contact WAECO
customer service.
Do not open the refrigerant circuit under any circumstances.
Set up the appliance in a dry location where it is protected
against splashing water.
Do not place it near naked flames or other heat sources (heat-
ers, direct sunlight, gas ovens etc.).
Ensure that the ventilation slots are not covered.
The appliance is not suitable for the storage of caustic materials
or materials containing solvents.
For use only on vessels over 20 meters in lenght.
Safety instructions
25