Nibe RTS 40 Installateurhandbuch Seite 6

GB
English, Installer manual - RTS 40
General
This accessory is used to obtain a more even indoor
temperature.
RTS 40 has up to three functions:
1. Show current room temperature in the heat pump's
display.
2. Option of changing the room temperature in °C.
3. Makes it possible to change/stabilise the room tem-
perature.
Install the sensor in a neutral position where the set
temperature is required. A suitable location is on a free
inner wall in a hall approx. 1,5 m above the floor. It is
important that the sensor is not obstructed from measur-
ing the correct room temperature by being located, for
example, in a recess, between shelves, behind a curtain,
above or close to a heat source, in a draft from an extern-
al door or in direct sunlight. Closed radiator thermostats
can also cause problems.
Changes of temperature in the accommodation take
time. For example, short time periods in combination with
underfloor heating will not give a noticeable difference
in room temperature. If the room sensor is used in a room
with underfloor heating, it should only have an indicatory
function, not control of the room temperature.
6
Contents
1 x Room sensor