Setup And Operation - Clearaudio smart matrix professional Bedienungsanleitung

User manual / Bedienungsanleitung
3. Set-up and operation
3.1
smart matrix professional
Place the
The surface should be waterproof. Please make sure that the machine is positioned safely and se-
curely.
TIP: We recommend keeping a towel near the machine to mop up any fluid spillage.
Please check that the microfiber strips are not worn out or dirty before each cleaning session as
using worn or dirty strips could damage to a record.
Dust and dirt can be removed with a toothbrush and rinsing under water.
To change the microfiber strips, peel them off the vacuum arm and carefully clean the tube with
an alcohol based cleaning fluid. Remove the protective backing from the spare microfiber strip to
expose the glue and stick them alongside the suction slot of the vacuum arm. Please take care not
to obstruct the suction slot with the microfiber strips.
Pic. 4: Changing microfiber strips
Pic. 5: Vacuum arm installation
6
machine on a clean, dry and stable surface.
smart matrix professional
The
after changing the microfiber strips. The adhesive takes 24 hours
to fully cure. If used too soon the strips may not hold properly to
the vacuum arm and could damage your records.
IMPORTANT:
Always check the microfiber strips before use. Heavily
soiled or worn strips can damage your records.
TIP: Microfiber strip lifespan is dependent on use. If
you are cleaning a lot of very dirty records you should
change the strips every 200 record sides.
Take the vacuum arm (Pic. 5) and insert it into the hole at the
front left hand side of the machine. Pay attention that the two
pins on the vacuum arm are aligned with the two cut outs in the
machine.
Push the vacuum arm down until it is fully inserted.
To remove the vacuum arm, pull it carefully upwards.
should not be used for 24 hours
© clearaudio electronic GmbH, 2017/11