Hensel PORTY 6 Lithium Bedienungsanleitung Seite 48

User Manual PORTY Lithium Power Pack
20
9:
RC/CH
15
21
17, 18
19
18
Strobe Wizard Plus transmitter
for radio flash triggering and power control
Connection
The Strobe Wizard Plus transmitter has no built-in main switch
for switching the unit ON. The transmitter is to be connected to
the camera either by attaching to its Hot Shoe or by
connecting the synchronization cable to the sync socket 22. If
it is connected to the Hot Shoe the unit must be carefully
tightened using locking screw 23.
Channel selection
The lateral sliding switch 20 allows to set 3 different working
channels. In addition, the option 'All' can be selected.
Pressing button 9 of the PORTY power pack activates the built-
in radio receiver (control LED lights up). Repeated pressing (> 3
sec) switches to the working channel selection: On the LED
display 15 appears ‚CH' and the number of the currently chosen
working channel (1, 2, or 3). Pressing the arrow buttons allows
to scroll between the channels. If the setting of the working
channel remains unchanged for longer than 3 seconds, the
channel is stored and the display changes to flash power
setting.
Test flash
By striking the „Test" key 21
shutter flashes can be triggered either selectively depending on
the working channel selected or all flash units together when
the option ,All' has been selected on the radio transmitter. In
total, 3 different working channels are available.
Besides flash triggering there are also options for adjusting the
flash power and modeling lamp available, that go either for all
flash units or the selected working channel:
1) Power adjustment
The buttons 17 and 18 offer further options for the power
adjustment: A single click of the respective button reduces
(18) and enhances (17) the flash power by 1/10 f-stop.
2) Modeling Lamp
Pressing button 19 for longer than 3 seconds switches the
modeling light on for about 30 sec.
The antenna is integrated in the handle.
or by releasing the camera
HENSEL Studiotechnik