Acclimatizing; Positioning; Automatic Overload Circuit; Lamp Connections - Hensel PORTY 6 Lithium Bedienungsanleitung

13:
READY
HENSEL Studiotechnik
Assembly
When mounting to a ceiling system or a pantograph,
suspended flash heads have to be doubly secured from falling
down or dropping. This is done by tightening the safety screw
at the HENSEL tilting head. Due to the existing
regulations, it is, however, necessary to use a safety rope
(Code No. 769) for further security.
The safety rope has to be led through the handle of the flash
head and then secured by looping through the bracket of the
pantograph or the eyelet of the carriage.
Heating
Due to the modeling and flash light, each generator and flash
head emits heat. This can heat up the parts of the unit to a
dangerous level. Therefore make sure, that generators and
lamp heads are located far enough from inflammable props to
avoid inflaming them. Take care for sufficient air supply and
make sure that ventilation slots of generators and flash heads
are kept free.
Do not operate power packs and flash heads unattended.

Acclimatizing

When moving generator from one climatic zone to the next, the
appliance should stand in the room, in which it will be operated,
for some time before starting it up. This might possibly prevent
internal shortcuts caused by condensing water.

Positioning

PORTY power packs can be operated standing up or lying
down.

Automatic overload circuit

Large series of subsequent flashes may trigger the automatic
overload circuit. After a break of cooling down, the power pack
is ready again for operation. The READY Indicator 13 flashes
up.

Lamp connections

EH Pro Mini 1200P Head (Code 3604)
EH Pro Mini 1200P Speed Head (Code 3607)
EH Pro 1200P Head (Code 3602)
All flash heads are specially designed for operation with the
PORTY power pack. For the EH Pro Mini Heads, max. 2
modeling lamps of up to 65W/12V halogen each can be used.
For the EH Pro Head, max. 50W/12V halogen can be used.
User Manual PORTY Lithium Power Pack
safety
9