AEG Electrolux 88031K-IN Benutzerinformation Seite 17

WARNING!
Risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by installing correctly.
• The appliance must be connected to the electrical supply by a qualified electrician.
• Loose and inappropriate plug and socket connections can make the terminal overheat.
• Have the clamping connections correctly installed by a qualified electrician.
• Use strain relief clamp on cable.
• In the event of single-phase or two-phase connection, the appropriate mains cable of
type H05BB-F Tmax 90°C (or higher) must be used.
• If this appliance's mains cable is damaged, it must be replaced by a special cable (type
H05BB-F Tmax 90°C; or higher). Please contact your local Service Force Center for further
advice.
A device must be provided in the electrical installation which allows the appliance to be
disconnected from the mains at all poles with a contact opening width of at least 3 mm
Suitable isolation devices include line protecting cut-outs, fuses (screw type fuses are to
be removed from the holder), earth leakage trips and contactors.
Sticking the seal to the rabbet
• Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive sealing tape supplied onto the upper surface of the
rabbet along the edges of the cut-out section.
• Cut the sealing tape into four pieces relating to the length of the edges of the rabbet.
• For the four corners of the rabbet the ends of the sealing tapes must be cut into mitres.
Do not stick the ends over one another.
• Stick the sealing tape flush into the corner of the rabbet, so that no silicon compound
can get under the glass ceramic when grouting.
• Don't stretch the tapes when sticking them on.
Assembly
Safety information
min. 500
min. 5
17
min.
50