Meta System M752A/15 Bedienungsanleitung Seite 16

FINAL CHECK
Once the connections to the central unit, carry out the following operations:
1) Make sure the car keys are not inside the vehicle.
2 Re-connect the battery.
3 The M752-15 LED will light for 10 seconds after which the central unit will emit 4 beeps.
4) Insert one of the two emergency
unit is enabled and will be in the disarmed operational
will flash once.
5 Close the windows, the doors,
6 Arm the M752-15 with the vehicle's original remote control. The arrows flash once.
7) During the first 25 seconds after arming the central unit will execute the initial immunity period
during which the LED will switch off for brief periods. Duringthis time, you can simulate an
intrusion by opening a door, the bonnet or the boot. The tuming indicators will flash. The
immunity period restarts after each test is carried out.
8) Once the initial immunity period has elapsed, signalled by reverse LED switching (the LED will
switch on for brief periods), if a door, the bonnet or the boot is opened an alarm cycle will be
generated.
9) If the cause of the alarm remains (e.g., a door left open), a single alarm cycle will be generated.
10) If the cause of the alarm iS Still present when the system iS armed (e.g., the bonnet iS Closed
badly) the M752-15 will give an acoustic signal followed by 3 beeps. If the cause of the alarm
remains, it will not generate an alarm cycle at the end of the initial immunity period.
II) The ultrasound system (M15 mykro) can be tested during the initial immunity period. Put
our hand through a window and move it to simulate an intrusion. The turning indicators will
ash to indicate an alarm cycle. Regulate ultrasound sensitivity with the trimmer if you feel it
is too sensitive or not sensitive enough. Use a screwdriver to adjust sensitivity but do not force
the trimmer or press down too hard on the screwdriver.
12) Make the key positive test during the initial immunity period. Turn the ignition key to
simulate an attempt to start the engine. The turning indicators will flash to confirm that an
alarm cycle was generated.
13) Once the initial Immunity period has elapsed, simulate an intrusion and, during the alarm
cvcle, check to make sure that the siren and the flashing turn indicators work properly.
14) Switch the control unit off using the remote control supplied with the car. The red LED
switches off and the arrows flash twice. If there was an alarm during the previous period the
system was armed, the LED will signal the Alarm Memory and there will be a double beep.
The Alarm Memory will be reset when the vehicle is started or the M752-15
The car doors will lock automatically
arming/disarming Cycle, if the vehicle's State iS not perturbed by door,'boot opening . The
M752-15 will be automatically
remote control. TO arm the alarm system again, lock and
control.
15) Test volumetric protection
positive (turning the ignition key on and off) 2 times and arm the central unit with the vehicle's
original remote control. The interval between these operations
The LED will stay on during the initial immunity period and when the system is armed you will
get 4 beeps. In this condition,the ultrasoundprotectionwill be disarmed untilthe central unit
IS disarmed again.
16) Check to make sure the emergency key works properly. With the anti-theft system armed,
insert one of the two emergency keys to disarm the system (this is not possible during a
current alarm cycle). Once the anti-theft system is disarmed, inserting one of the 2 emergency
keys will switch the system off completely and this will be signalled with 4 beeps. Once the
anti-theft system has been switched off, switch it back on in disarmed Status. An emergency
key can be substituted if lost or mislaid. To do this, disarm the central unit completely with the
remaining emergency key and reinsert the key for about 15 seconds. The LED will stay lit and,
at the end, you will get a short acoustic signal. Remove the key, the LED will flash very quickly
to indicate that the lost key has been deleted and that the system is waiting for the new key.
Insert the new key in the slot. System self-learning is automatic.
keys in the slot and hold it in for at least a second. The control
status (disarmed alarm) and the LED
the bonnet and the boot.
and the M752-15 will be armed 1 minute after the last
disarmed when opening the trunk by means of the original
(M15 mykro) disarming. To do this, arm and disarm the key
16
EN
is armed again.
the car doors using the remote
must not exceed 20 seconds.