Timer Settings - Ecolab Smartpower Rinse Pulse Timer Montageanleitung

Timer settings

Pulse timer settings can be changed via toggle switches on the board.
In the default setting, the toggle switches are set as follows:
Fig. 3: Default setting of the pulse timer board
Timer: ON/OFF, default: OFF
1
ON time: 0.4 s or 0.8 s, default:0.8 s
2
OFF time: 18 s or 36 s, default:18 s
3
NOTICE!
Device testing
During testing of the SMARTPOWER Rinse, ensure that the pulse timer is
deactivated via the setting of the corresponding toggle switch.
In this way, you also deactivate the timer function if this operating mode is
not desired.
B
LED blinks when water valve is on
A
Heartbeat blinks when 24VDC is present
B
7
Installation
1
2
3
A
SON053438 Rev 2-09.2025