ECOLAB SMARTPOWER Rinse Pulse Timer Montageanleitung Seite 10

Retrofitting pulse timer board for SMARTPOWER Rinse
1 Retrofitting pulse timer board for SMARTPOWER Rinse
In order to improve the performance and concentration stability of the rinse aid
dosing unit SMARTPOWER Rinse, a Rinse Pulse Timer Board (PCB) can be installed in
the housing. These instructions document step by step how this is done.
The following tools are required for retrofitting:
Philipps screwdriver
Only use Philipps screwdrivers in accordance with ISO 8764.
Wire cutter
A wire cutter is used to cut cables. It should always have insulated handles.
Wire stripper
The use of these pliers for stripping cables and electrical wires avoids damage to the
conductor when cutting the insulation.
SON053438 Rev 2-09.2025 2