purline FIRECOOL RUSTIC 70 Anleitung Seite 26

EN
DESCRIPTION
Manual water filling
Air outlet
INSTRUCTIONS FOR USE OF THE PRODUCT
1. The product should be placed horizontally, inclined placement may result in poor
atomization effect or mist and product failure.
2.
Connect the power cord to the power supply before turning on the product. The
digital display shows "OF". Next, open the small water cap on the cover plate, exposing
the water injection port, insert one end of the silicone soft water pipe into the water
injection port, and connect the other end to the external water container such as carafe
or basin, and then double click the water injection button to inject water, when the
injected pure water reaches the appropriate water level in the tank, the water level
sensor probe in the tank will automatically send a signal to stop the water injection
pump. At this time, it means that the water has been pumped out. Pull out the water
injection tube and put the water cap on. Press the ignition button and wait about 10
seconds for the flame to appear.
3.
The water in the tank will be consumed slowly during the process of product operation
(the rate of water consumption is proportional to the exuberance of the flame fire, and
the more vigorous the fire, the faster the water will be consumed). When the water in the
tank is lower than the induction position, the machine will automatically stop working
and buzz every 15 minutes to inform the user that the water needs to be refilled, and
if no longer remember the shortage of water after more than 1 hour.
26
Simulated flame
output
Control display
Electric water filling port (electric
draining port)
Electric cable