HOMCOM YH-20 Bedienungsanleitung Seite 4

EN
Instructions to use
OFF
Overheating safety device
If the heater stops working, turn it off and check if the inlet or outlet is blocked. Unplug
the unit and wait at least 10 minutes, so the protection system can reset. If the heater
still does not work, contact customer service for inspection or repair.
Attention: Before restarting the heater, ensure it has been unplugged for at least 10
minutes.
Cleaning
1. Always unplug the unit before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum or any other detergent or chemical solvent to clean the heater.
4. When the heater has not been used for a while, store in a clean, dry place, away from
dust and dirt.
Disposal
Environmental Protection
Waste electrical production should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice.
ON
1.Thermostat control knob (TEMPERATURE SETTING)-
Adjust to maintain room temperature
1
2. Flame switch - Switches flame effect and power on/off.
3. Heating setting: please press "
2
4. Heating setting : please press"
3
time for 2000w (can not operate without first press"
4
4
" for 1000W.
"and " "at the same
" ).