Operation; Remote Control; Switching On/Off; Inserting A Cd - Omnitronic XDP-1400MT Bedienungsanleitung

6. OPERATION

The XDP-1400MT can either be operated via
the buttons on the front panel or via the remote
control. However, via the remote control it is not
possible to browse the folders on a CD or a
storage medium.

Remote control

1
When actuating a button, always direct the
remote control towards the sensor. There
must be no obstacles between remote
control and the sensor.
2
If the range of the remote control decreases,
the batteries are probably exhausted and
must be replaced.

Switching on/off

1
Switch on the XDP-1400MT with the
power button.
• The unit will automatically detect if a CD is
inserted (indication "READING").
• If a CD is inserted, the display will shortly
indicate the total number of titles and the
total remain time followed by information
concerning the first title after the read-in.
• If no CD is inserted "NO DISC" will be
displayed.
2
Prior to switching the unit off, always
terminate the playback with the button [►II]
or the button []. Then press the power
button to switch off the unit.

Inserting a CD

1
To insert a CD, open the CD tray with the
button [ ].
• The control LED lights.
• The display will show "Open".
2
Insert the CD with the lettering facing
upwards and close the CD tray again with
the button [ ].
• The display will show "CLOSE".
• The control LED lights during the read-in.
Loading and removing USB devices
and memory cards
1
Insert USB devices into the USB port.
• To remove a USB device, disconnect it from
the USB port.
2
Insert a memory card with the contacts
pointing downwards and the notched corner
to the left so far into the card slot until it
engages.
• To eject a memory card, slightly press the
card in until it comes out and can be
removed.
3
Prior to removing a storage medium, always
terminate the playback with the button [►II]
or the button []. Otherwise damage or loss
of data may occur.

Regarding data carriers
• This unit supports data carriers with the file
system FAT32 and with a capacity up to 32
GB.
• This unit supports MSC (Mass Storage Class)
USB storage devices 1.0, 1.1, 2.0 including
external portable flash memory devices and
digital audio players. However, hard discs,
optical discs such as external CD/DVD drives
will not be recognized. Depending on the
device used, proper playback may not be
possible with all USB devices.
• This units supports SD(HC) and MMC memory
cards.
• If a data carrier is not recognized at the first
try, remove it and insert it again.
31/38 00075259.DOC, Version 1.0