DUROFIX RW1216-3 Produktinformationen Seite 10

INSTALLING SOCKETS
Always follow the procedure below to install a socket.
1. Insert a socket into the anvil (see Fig.3).
2. Make sure the bit is fixed in the anvil while clicking on the ball of the anvil.
REMOVING SOCKETS
1. Always follow the procedure below to remove a socket. Pull out the socket from
the anvil of output drive directly. (see Fig. 3)
CAUTION
wrench on bag, work table, tool cabinet.....etc.
FORWARD / REVERSE LEVER
The tool is equipped with a forward/reverse lever (see Fig. 4A), which was designed to
change rotation of the output drive.
1. For forward rotation, turn the lever counter-clockwise to the "F" position.
2. For reverse rotation, turn the lever clockwise to the "R" position.
1English1
Fig. 2
Fig. 3
Always set lock button (4) to off position when installing and
removing socket or prevent the switch on when place the
Counterclockwise
A
(output drive pointed away from you)
Fig. 4
OPERATION
English
Clockwise
-9