Caliber PMT 701DAB Bedienungsanleitung Seite 6

MANUAL
Below the descriptions of the features/options of the PMT 70IDAB.
The numbers between the
The illustrations
Operating your PMT701DAB:
Use the provided power cord, plug one end into the PMT 701DAB (1)
and plug the other end into the Car Cigarette lighter Socket (10—30V).
2. Hold down the [Power] button (6) for 3 sec.
For first time use, you need to scan all the local DAB+ channels by
3.
pressing [Menu] button (7) for 3 sec. and [Enter) button (6) to activate
the "Full Scan-,
until another "Full Scan" is performed. During scanning, a scan moving
bar will be shown in the display to indicate the progress and the total
number of channels
Once it is scanned, you can select any DAB+ radio channels by
4.
pressing [+1 and (41 buttons.
Receive signal from the PMT 701 DAB through
1. Connect your car head unit "ALJX-in•or "Line-in" to the (AUX-out] jack (5) on
the right-hand side of the PMT with the provided 3.5mm jack-to-jack cable.
Receive signal from the PMT 701 DAB through
Select FM Transmitting Frequency (Transmit Mode):
1. Tune your car head unit to a vacant frequency for transmission of
the audio signal from your PMT 701 DAB to your car head unit.
2. Hold down the [Menu) button (7) for 3 sec. and use the
to go 'Transmit Mode', then press (Enter) (6).
3. The frequency on the PMT 701DAB can be adjusted manually by
pressing [+] and
choose on the
Remarks:
"Vacant frequency" means there is no any radio broadcasting content or
noise when the frequency is selected.
refer to the key or connections on the unit.
can be found in the
all available radio channels
received.
buttons, to the frequency similar to the one you
car head unit.
front of this manual.
will be scanned
line out cable:
FM transmission:
and saved
button