RAPTURE PYTHON RPT-GMW100P01 Bedienungsanleitung Seite 5

OVERVIEW
1
3
Left mouse button
1.
2. Centre wheel
Side buttons forward
a.
4. Cable
Right mouse button
S.
DPI+/DPI- button (resolution
7. Optical sensor
INSTRUCTIONS
Installation
Plug the USB end of the interface
port on your computer. The mouse is installed
so you can control the mouse
Software
You can download the advanced
using the QR code provided.
www.alzashop.com/rapture-software
Turning the mouse On/Off
The mouse turns on automatically
computer. The RGB backlight
when the mouse is turned
If gou shut down or put the
also shuts down.
RGB backlight settings
The Rapture PYTHON mouse is equipped
backlight effects. To switch
the center wheel and the side back button
RGB backlight effects will change
Backlight is off.
I.
Gradual switching on and off of the backlight
of one color
Gradual switching on and off of the backlight
a.
vidual colors
4. Neon backlight
Backlight in waves
S.
/ backward
setting)
cable into the appropriate
automatically
quickly and comfortably.
mouse setup software
when you turn on your
turns on automatically
on.
computer to sleep, the mouse
with S RGB
between the effects, press
repeatedly.
in the following order:
in indi-
4
7
Resolution setting
You set the resolution
the DPI + and DPI-
gou increase the sensor
tton you decrease
Each sensor resolution
When changing
of the given resolution
DPI level
600 DPI
800 DPI
1,200 DPI
1,600 DPI
2,400 DPI
3,600 DPI
e,æoo DPI
Note: The sensitivity
downloaded software,
CLEANING
Keep the wire mouse
cable connector
before cleaning.
USE only dru and clean
harsh cleaners, solvents,
stances. Never wash
The
of the mouse sensor
buttons, where with the
resolution and with the DPI- bu-
the sensor resolution.
level has its own backlight
the DPI, the mouse flashes
level.
Calar backlight
Red
Green
Blue
Yellow
Turquoise
Purple
White
of the sensor can also be set in the
up to 10,000 DPI.
clean. Always disconnect
from the USB port of your computer
cloth for cleaning.
gasoline or other similar
or immerse the wire mouse
with
DPI + button
color.
the color
the LJSB
Do not use
sub-
in water.
5