VEVOR MK1102M Bedienungsanleitung Seite 5

10. Pedestrians should never cross the pathway of a moving gate. The gate
opener is not acceptable for use on any pedestrian gate. Pedestrians must be
supplied with a separate pedestrian access.
11. For an installation utilizing non-contact sensors (safety sensors), see product
manual on the placement of non-contact sensors (safety sensors) for each type of
application.
12. Care shall be exercised to reduce the risk of nuisance tripping, such as when a
vehicle trips the safety sensor while the gate is still moving.
13. One or more non-contact sensors (safety sensors) shall be located where the
risk of entrapment of obstruction exists, such as the perimeter reachable by a
moving gate or barrier.
14. Never mount any device that operates the gate opener where the user can
reach over, under, around or through the gate to operate the controls. Controls are
to be placed at least 6' (1.8m) from any part of the moving gate.
15. Controls intended to be used to reset an operator after 2 sequential activations
of the entrapment protection device or devices must be located in the line of sight
of the gate, or easily accessible controls shall have a security feature to prevent
unauthorized use. Never allow anyone to hang on or ride the gate during the entire
travel of the gate.
- 4 -